How to Remove Your Old Motocross Graphics Before Installing New Ones?

 

Are you planning to add some more spark to your KTM bike by using the KTM 150 Graphics Kit you recently purchased? If yes, you have certainly taken a good decision. However, before you move ahead and install the new graphics, you must get rid of the old ones your bike has.
 
You are wrong if you think that removing graphics is an easy job. For some, this job turns out to be even more complicated than installing new graphics. The section below will help you to learn the easiest way of getting rid of the stickers and graphics on your two-wheeler.

Why Removing Old Bike Graphics Is So Difficult?

When the graphics on our bike remain exposed to the sun for prolonged periods, the plastics they are printed on tend to get baked. This makes it almost impossible to peel those stickers off from their edge. Here, it must be noted that if you use high-quality products like the KTM 150 Graphics Kit, you are unlikely to face the above situations.
 
This leaves us with the question, how one should remove old graphics when their edges get stuck on the bike’s surface. The next section includes a detailed answer to this question.

How to Remove Old Motocross Graphics from Bikes?

Step 1: Find your hairdryer. If you don’t use one, borrow one from your neighbor or buy a new one. You will not be able to accomplish the job without a hairdryer.
 
Step 2: Turn on the dryer. Keeping it in high mode, hold it around an inch above the graphics. Use the dryer to apply heat onto the sticker for around 30 seconds. Make sure that your old sticker is not getting too hot. That’s because excessive heat can end up softening the bike’s paint.

Step 3: Find a credit card that is no longer in use. Use the card for picking at the sticker’s edge. Continue until the sticker comes up. If you still fail to remove the sticker, apply some more heat to the area. After 30 seconds of heat application, repeat the same action using the card. This time, you shouldn’t find it difficult to peel the sticker up.
 
Step 4: After removing the sticker, you will most likely have some glue on your bike’s surface. Remove the glue using a solution prepared by mixing alcohol and water. Allow the area to dry up and you are now ready to begin the installation of the new KTM motocross graphics.

If you feel that the above steps are too complex, you can hire a professional to do the entire job on your behalf. The person will also install the new stickers to give your bike a more striking appearance.

Blog Source: https://blog.storymirror.com/read/11r8nvia/how-to-remove-your-old-motocross-graphics-before-installing-new-ones